2006 Mustang Exterior Door Handle Removal

This pair of chrome exterior door handle covers are designed out of a high quality plastic that is coated in chrome style finish.

2006 mustang exterior door handle removal. Remove the door trim handle panel cover and the panel trim bolt in the recess of the door pull. Exterior Door Handles by Mustang America. Disconnect the exterior door handle actuating rod from the front door latch assembly.

This will prevent scratches when the door panel is being removed. You are now a Mustang door panel removal. Raise the manual lock rod to the unlock position.

Remove the 2 handle retaining nuts 4 and remove the outside door handle assembly 2 from the door outside handle bracket assembly 3. Remove the door outside handle bracket assembly 3 from the door if necessary. Gently prise the white lever and the door handle apart and then pull the handle outwards.

Figure 1 ACTION The concern is caused by pre-loadingbiasing the exterior door handle actuating rod the front door. Grab your drill and drill through the head of the rivet making sure to stop once the head pops loose. Undo all the screws located on inside handle down low on the inside panel and a few in the middle I think 2.

You can use a piece of cardboard with a notch in it or you can buy a door handle remover tool from a car part store. This bolt holds the lock cylinder and handle in place. Remove the window control switch housing and disconnect the electrical connector.

Disconnect the door handle cable from the handle. 10Move to the outside of the door and work the handle through the holes. Before opening the door put some painters tape or other weak tape along the front edge of the exterior door skin near the hinge and along the rear of the fender gap.