Watco Exterior Wood Finish Instructions

It creates the rich warm glow of a traditional hand-rubbed finish.

Watco exterior wood finish instructions. So a Janka rating is an average of numerous tests performed on all directions and numerous pieces. I have redwood benches in my back yard. 1 quart covers up to 170 sq ft.

Allow the stain to penetrate 5-15 minutes to achieve desired color. After 30 minutes reapply liberal amount of finish. Waxed finishes and all dirt and grease should be removed with white spirit on a rag using vigorous agitation.

Using a soft bristle brush coat the brush with Watco oil and be extra careful to ensure there are no oil drips from the hairs of the brush. The woods natural beauty is restored. Apply stain in the direction of the grain with a brush or clean cloth.

The can says it will stain seal and protect all in one coat. Allow at least 8 hours to dry before light use. Wait for approximately 15-minutes for the wood to fully absorb the oil finish.

Use on decks fences siding and outdoor furniture. If you want a semi-gloss varnish finish just start with a varnish in the first place. After an additional 15 minutes penetration wipe wood completely dry.

All the samples had rough surfaces. Shake container thoroughly and test for color on a hidden section of wood. Remove stain that has not absorbed into the wood with a clean cloth.